7
Revision date: 04.17.20
2-Layer Film Install
1
2
3
108553 Wafer
Head Screws
Gather Parts and Tools:
• PGFLSAXXFCW0063 Flashing (8' long)
• 108553 Wafer Head Screws
• Clutched Drill Driver and Phillips Head Bit
• Tool to cut metal flashing.
• Tape Measure and Marker.
Complete these steps:
1. Take one section of PGFLSAXXFCW0063 flashing and place it in place on end
rafter.
2. Mark flashing where rafter begins to bend. Place flashing on ground or work bench.
3. From first cut, mark remainder of flashing face at 12" on-center intervals.
Flashing (PGFLSAXXFCW0063) Installation
ATTENTION:
To bend flashing more easily, decrease the on-center spacing of cut
lines. Spacing between cuts depends on rafter. Cut as needed for desired results.
4. Using snips or a saw, cut flashing face to the bend in flashing. Flashing face is the
part that overlaps tops of end panels.
12"
96"
PGFLSAXXFCW0063 Flashing
Bend
4
5. Repeat steps to cut flashing face to the flashing bend to make additional cuts.
