6
2-Layer Film Install
Revision date: 04.17.20
End Panel Installation Details & Foil Tape Install
End panels are rounded and follow contour of end rafter. (See diagram below.) If needed, cut end panels so top of end panels are flush with top of end rafter.
Apply foil tape (DH8007) to cover all open cells after cutting and before flashing (if this has not been completed yet). U-channel flashing overlaps end panels
to cover open cells at top. If end panels are prepared, continue with instructions on the next page. (Actual end wall with panel layout may differ from example
shown. End panel preparation is the same.)
Cut panels to size and apply foil
tape to cover open cells if this has
not been completed yet.
