Grove toucan 1010, Service Manual

Page: 72 / 73

Toucan 1010
Models
Revision 02-2000
72
MIN
MAX
LOCATION LUBE TYPE LUBE INTERNAL LUBE AMOUNT APPLICATION
2. Lifting chains
MOBIL DTE 16M
Viscosity : 68 cSt at 40°C
Viscosity index : 142
Pour point : -45°C
Every 125 hours or
once every 30 days of
operation or more often
if the platform is used
or stored in a very
dusty or corrosive
environment.
N/A
Lubricant can be applied
manually with a brush or by
spraying.
Apply lubricant :
- Longitudinally = in areas where
joints are under small load to
facilitate penetration of the
lubricant.
- Transversally = between the
plates to enable the lubricant to
reac
3. Wheel
bearings (non-
drive hubs)
MOBILUX EP2
(Lithium base grease) Every 250 hours of
operation.
N/A
1 Grease nipple
on each hub
4. Swing
bearing race MOBILUX EP2
(Lithium base grease) Every 250 hours of
operation.
N/A
1 Grease nipple on turntable base
plate
5. Main
hydraulic
reservoir
MOBIL DTE 13M
Viscosity : 32 cSt at 40°C
Viscosity index : 155
Pour point : -48°C - Check daily.
- Drain after 1000
hours of operation or at
least every 2 years.
21,5 l
Fill through top in-tank return
filter.Check
level through the
sight gauge on
the reservoir.
6. Return filter
7. Pressure
filter
8. Steering unit
reservoir
MOBIL DTE 13M
Viscosity : 32 cSt at 40°C
Viscosity index : 155
Pour point : -48°C
- Check every 125
hours of operation.
- Drain after 1000
hours of operation or at
least every 2 years.
1l
Check level/fill through reservoir
breather cap.
9.Swing bearing
internal gear
MOBILTAC 81
or
MOBILITH SHC 1500
Every 1000 hours of
operation.
Coat all teeth.
1- Remove swing gear box
2- Apply a thick coat of grease
with a brush through the gear box
centering hole. Manually rotate
the turntable to reach the whole
teeth.
Element replacement interval : After first 50 hours of operation and every 250 hours thereafter.
Element replacement interval : After first 50 hours of operation and every 250 hours thereafter.
LUBRICATION 7 7