Grove toucan 1010, Service Manual

Page: 51 / 73

51
Models
Revision 02-2000
Toucan 1010
4- Use a plumb line to ensure the vertical
alignment of the mast sections is kept :
5- Tighten the roller pin locknuts.
Torque value : 1000 N.m approximately.
If during adjustment one of the mast sections
jams, stop the lowering movement and raise
the mast to retension the chains. Loosen
slightly the roller pins of the jammed mast.
Controls after adjustment
- Fully raise and lower the telescopic mast two
or three times with the rated load (200 kg)
evenly distributed in the platform.
- If no jamming occurs, fully raise and lower
the telescopic mast with one person in the
platform.
- If jamming occurs during lowering, loosen
slightly the roller pins of the jammed mast
section.
- Check the torque value of all roller pin locknuts.
Do not hesitate to contact your approved Grove
Manlift distributor for more information.
! CAUTION
5.18 Lifting chains adjustment
The lifting chains of a same stage must have an
identical tension.
The chains must always be tensioned so that the mast
sections are slightly offset towards the top :
Control of tension :
1- Fully raise the telescopic mast.
2- Lower the mast by approximately 50 cm.
3- Press on each chain between the pulley and
chain yoke. Each chain of a same stage must
have the same deflection.
4- Fully lower the mast.
5- Raise the mast by approximately 50 cm.
Ensure the deflection is the same for each
chain of a same stage :
Tighten the nut on the anchor
of the chain which is too slack
or loosen the nut on the anchor
of the chain which is too tight,
ensuring the final offset of the
mast sections is kept.
6- Check the presence and correct tightening of
the locknut on each chain anchor.
NOTE
Refer to Section 7. LUBRICATION for chain
lubrication procedure and lubricant
specification.
4
to
6
m
m
4
to
6
m
m
4
to
6
m
m
4
to
6
m
m
Deflection
INCORRECT
Plumb
line
CORRECT
Plumb
line
Plumb
line
MAINTENANCE 5 5