Grove toucan 1010, Service Manual

Page: 29 / 73

29
Models
Revision 02-2000
Toucan 1010
4.2.1 "Fulmen" charger.
Charger panel
a. Circuit breaker.
b. Display.
c. Equalisation function button.
d. 100% charged LED indicator.
e. Charger ON LED indicator.
f. 80% charged LED indicator.
g. ON/OFF button.
Power supply : 110VAC - 60Hz / 220VAC - 50Hz
- Adaptation to network voltage :
a
b
d
f
g
e
c
DANGER
+ 0 1 2 3 4
Jumper
+ 0 1 2 3 4
Jumpers
Prior to any operation requiring charger
cover removal, the battery must be
disconnected and the charger must be
unplugged from the AC outlet. Failure to do
so could result in death or serious injury to
personnel.
Connections on transformer inlet terminals block :
220 VAC - 50 Hz 110 VAC - 60 Hz
- Protections :
Single pole circuit breaker :
- 15 Amps on 24 MO 40A models
- 20 Amps on 24 MO 65A models
Output fuse :
- 40 Amps on 24 MO 40A models
- 80 Amps on 24 MO 65A models
NOTE
A spare output fuse is strapped inside the
charger cover.
Troubleshooting chart :
Display Probable cause Solution
EO Charger in test mode
Move the jumper from "test" position to
"propor." position on the electronic card.
E1
Output fuse faulty
Low intensity Replace the fuse. Check voltage at output and
input of the transformer.
E2 Fault on electronic card Contact Grove Manlift Product Support.
E3
Electronic card programme erased
(configuration lost)
Contact Grove Manlift Product Support.
E4 Batteries too discharged
Leave the batteries to rest before resuming
charge.
E5 Electronic safety. Safety time switch faulty
Disconnect and reconnect the batteries. Contact
Grove Manlift Product Support if the fault
persists.
E6 Battery incorrect nominal voltage
Connect the battery from the work platform to
the charger.
BATTERY - CHARGER 4 4