Grove toucan 1010, Service Manual

Page: 54 / 73

Toucan 1010
Models
Revision 02-2000
54
5.21 Tilt alarm
General
This machine is fitted with a tilt sensor. The device is
located on the front of the frame.
Tilt sensor
Check :
1- Position the selector switch to "Ground
controls" or "Platform controls"
2- Chock the rear wheels.
3- Place a spirit level (digital display) on the
chassis positioned lengthways from
À
-
Á
.
4- With a jack of appropriate capacity, lift the
front of the chassis in
À
:
- An acoustic alarm sounds when the chassis
is tilted at 2°.
- The corresponding LED alarm lights up on
platform controls.
5- Chock the front wheels.
6- With a jack of appropriate capacity, lift the
rear of the chassis in
Á
.
- An acoustic alarm sounds when the
chassis is tilted at 2°.
- The corresponding LED alarm lights up on
platform controls.
7- Place a spirit level (digital display) across the
chassis from
Â
-
Ã
.
8- With a jack of appropriate capacity, lift the
right hand side of the chassis in
Â
.
- An acoustic alarm sounds when the
chassis is tilted at 2°.
- The corresponding LED alarm lights up on
platform controls.
9- With a jack of appropriate capacity, lift the left
hand side of the chassis in
Ã
.
- An acoustic alarm sounds when the chassis
is tilted at 2°.
- The corresponding LED alarm lights up on
platform controls.
Setting :
If the tilt sensor does not work symetrically in the
direction
À
-
Á
:
- Correct the symetry fault by tightening or
loosening the nut C .
If the tilt sensor does not work symetrically in the
direction
Â
-
Ã
:
- Correct the symetry fault by tightening or
loosening nuts A or B .
1
2
3
4
B A
C
MAINTENANCE 5 5