OM/SM-TDH-CE
13
e) Remove thermostat phial from kettle base and
withdraw the thermostat.
f)
Replace in reverse order.
g) Ensure an adequate sealant is used to seal the
replacement thermostat Phial Boss.
h) Once the thermostat is in place, the jacket
should be refilled. (Paragraph 3.3).
Always refer to the wiring diagram when
reconnecting electrical leads. The wiring
diagram is located inside the appliance and at
the rear of this manual.
3.13 Remove Pressure Switch
a) Remove panel from base of kettle by undoing
the retaining nut.
b) Disconnect pressure switch electrical leads.
c)
Remove the microswitch and retaining bracket.
This will allow the pressure sensor section to be
removed from the kettle base.
d) Allow the kettle to drain by undoing the pressure
switch connection in the kettle base. Drain into a
suitably sized container.
WARNING
ENSURE THAT ELECTRICAL LEADS AND
CONNECTIONS IN THE KETTLE BASE DO
NOT GET WET. REMOVE IF REQUIRED
e) Remove and withdraw the pressure sensor
section from the kettle base.
f)
Replace in reverse order.
g) Once the pressure switch is in place, the jacket
should be refilled (Paragraph 3.3).
3.14 Remove Low Water Level Sensor
(Turn gas and electric mains off
)
a) Remove panel from base of kettle by undoing
the retaining screws.
b) Disconnect the electrical leads from the water
level sensor.
c)
Drain the kettle by tilting the kettle slightly and
undoing the low water level sensor. Allow the
kettle to drain into a suitably sized container.
d) Remove the low water level sensor from the
kettle base.
e) Replace in reverse order
f)
Ensure a suitable sealant is used to seal the low
water level sensor Boss.
g) Once the low water level sensor is in place, the
jacket should be filled (Paragraph 3.3).
3.15 Remove Burners
(Turn gas and
electric mains off)
a) Tilt the kettle until the burners are fully exposed.
b) Disconnect the pilot assembly from the burner
guard.
c)
Remove the retaining nuts securing the burner
guard to the appliance base.
d) Remove the burner guard.
e) The burners are now accessible and can be
removed as required.
f)
Replace in reverse order.
g) Ensure adequate sealant is used to seal the
burners.
ALWAYS CHECK FOR GAS SOUNDNESS WHEN
ANY PART OF THE GAS CIRCUIT HAS BEEN
DISTURBED.
3.16 Remove Pilot Assembly/Pilot
Injector
(Turn gas and electric mains
off)
a) Undo pilot pipe compression fitting.
b) Remove pilot pipe from pilot assembly
c)
If the pilot injector is to be changed, it may be
done at this stage. Remove the pilot injector
from the pilot assembly. Change, clean or
replace as required.
