Model T30945 (Mfd. Since 12/19)
-19-
Disabling & Locking
Switch
Figure 18. Switch disabled by a padlock.
Figure 19. Maximum lock shaft requirements.
NOTICE
The padlock shaft diameter is important to
the disabling function of the switch. With
any padlock used to lock the switch, test
the switch after installation to ensure that it
is properly disabled.
Children or untrained people can be
seriously injured by this machine. This
risk increases with unsupervised operation.
To help prevent unsupervised operation,
disable and lock the switch before leaving
machine unattended! Place key in a well-
hidden or secure location.
6mm
The switch can be disabled and locked by insert-
ing a padlock through the ON/OFF paddle switch,
as shown. Locking the switch in this manner can
prevent unauthorized operation of the machine,
which is especially important if the machine is not
stored inside an access-restricted building.
IMPORTANT: Locking the switch with a padlock
only restricts its function. It is not a substitute
for disconnecting power from the machine when
adjusting or servicing.
Padlock
ON/OFF
Switch
Cutting Tips
•
Move tile slowly through the cut to reduce
chipping.
•
Ensure blade is consistently wet at point of
cut.
•
If blade becomes dry, stop cutting.
•
If motor sounds as if it is slowing or strug-
gling, stop or reduce cutting speed.
•
Slow down and ensure tile is still well sup-
ported as you near end of the cut.
•
Replace water in bath frequently.
•
Clean, dress blade with a dressing stone, or
replace the blade when abrasive portion is
worn away or glazed.
To ensure the best possible results from this saw,
use the following tips.
Changing Water
Never cut tile dry. The water bath reduces dust,
heat buildup on the blade, and prevents tile break-
age. Replace bath with fresh water whenever
it becomes discolored, or you notice debris on
blade during operations.
Waste water must be disposed of in accordance
to local regulations and laws.
To change water:
1. DISCONNECT MACHINE FROM POWER!
2. Position saw over gallon bucket to catch
water as it drains.
3. Remove bevel table and drain water from
bath by pulling overflow drain plug.
4. Rinse tank, re-install drain plug, and replace
with fresh water before connecting to power
and resuming operations.
Summary of Contents for T30945
Page 40: ......
