Model T30945 (Mfd. Since 12/19)
-21-
3. Unlock rip fence by lifting rip fence lock lever,
adjust to desired cut width on scale, and push
lock lever down to secure (see
Figure 24).
Figure 24. Rip fence lock lever location.
4. Position tile flush against miter guide at front
of saw.
5. Loosen splash hood lock knob and adjust
hood to height of tile (see
Figure 25). Hood
should be as close to tile as possible without
touching.
Figure 26. Tile ready for miter cut.
Top view
Tile
7. Ensure blade is wet, then push tile through
cut (see
Figure 26).
Figure 25. Splash hood lock knob location.
6. Connect machine to power and turn ON.
Splash Hood
Lock Knob
Making Bevel Cuts
The bevel table allows for bevel cuts when adjust-
ed up at a tilt. The two support legs have stops
at 22.5˚ and 45˚ for easy adjustment to common
bevel cuts.
To make a bevel cut:
1. DISCONNECT MACHINE FROM POWER!
2. Unlock and remove rip fence and attached
miter guide from saw table.
3. Tilt bevel table up and adjust insert table legs
to desired angle stop (see
Figure 27).
Figure 27. Bevel table set to 45˚.
Rip Fence
Lock Lever
Table Legs
Summary of Contents for T30945
Page 40: ......
