Grizzly T30945, Owner'S Manual

Page: 26 / 40

-24-
Model T30945 (Mfd. Since 12/19)
6. Remove outer flange and blade from arbor
(see Figure 38).
Removing &
Installing Blade
The Model T30945 uses abrasive continuous-rim
blades. This type of blade does not cut and wear
like typical "toothed" blades, instead they cut and
grind simultaneously, making them perfect for
ceramics. To maintain the optimal cutting capabil-
ity of your tile saw, the blade should be changed
when the abrasive portion of it has worn away
or becomes glazed over and dressing is not an
option.
Items Needed Qty
Replacement Blade ( #PT30945084)................. 1
Bucket 1-Gallon ................................................. 1
Open-End Wrench 19mm .................................. 1
Arbor Wrench 8mm ........................................... 1
1. DISCONNECT MACHINE FROM POWER!
2. Position saw over bucket to catch water as it
drains.
3. Remove bevel table and drain water from tray
by pulling overflow drain plug.
4. Loosen splash hood lock knob, lift hood
fully, and tighten lock knob to secure (see
Figure 36).
Figure 36. Splash hood in up position.
Splash Hood
Removing Blade
Arbor
Arbor Nut
Inner Flange
Outer Flange
Blade
Figure 38. Correct order of blade installation.
3. Secure inner flange, blade, and outer flange
on arbor with arbor nut.
4. Replace overflow drain plug and bevel table.
5. Fill bath with water before resuming
operations.
1. Place blade on arbor flush against inner
flange, being sure blade arrows point toward
front of saw (see
Figure 38).
2. Place outer flange on arbor and turn it until
it rests flush against blade (see
Figure 38).
Blade should spin freely without side-to-side
movement on arbor.
Installing Blade
Figure 37. Loosening arbor nut.
Arbor Wrench
Open-End
Wrench
Splash Hood
Lock Knob
5. Use arbor wrench to secure arbor then remove
nut with open-end wrench (see
Figure 37).