Grizzly T1244, Owner'S Manual

Page: 15 / 32

Model T1244 (Mfd. Since 10/17)
-13-
4. While assistant holds router table extension
wing from above, attach extension wing to
saw table using (3) supplied M10-1.5 x 40 hex
bolts, (3) 10mm flat washers, and (3) 10mm
square washers (see
Figure 13), or Grade 5
fasteners obtained in Step 3.
Figure 14. Use square washer, flat washer, and
hex bolt to attach router table wing.
Square
Washer Flat Washer
Hex Bolt
Square
Washer
Orientation
Options
10mm
Square
Washer
10mm
Flat
Washer
M10-1.5 x 40
Hex Bolt
Router Table
Extension Wing
Main Table
Figure 13. Mounting router table extension wing
to saw table.
5. Place straightedge across saw table and
router table extension wing to make sure that
combined table surface is flat.
— If combined table surface is flat, continue
with
Step 6.
— If outside edge of router table tilts down,
remove extension wing and place strips of
masking tape along bottom edge of saw
table to shim router table up and even
with the saw table from side to side (see
Figure 15).
Tape
Figure 15. Using tape to shim the router table
up.
Note: Adjust square washer orientation under
hex bolt (see
Figure 14) so that washer clears
bottom of router table extension wing and sits
flush on flange while aligning mounting holes
with saw table.
3. With assistant's help, remove right extension
wing of saw table and use mounting holes
shown in
Figure 12 to attach router table
extension wing.
IMPORTANT: DO NOT re-use hex bolts
used previously to attach right extension
wing. They may be the wrong grade or too
short. Use the supplied M10-1.5 x 40 hex
bolts, or buy new 1
1
⁄
2
" long Grade 5/Class 8.8
hex bolts if your saw uses a thread size and
pitch other than M10-1.5.
If the mounting holes DO NOT align, use the
router table extension wing as a template
to mark mounting hole locations on the saw
table. Drill and tap three M10-1.5 holes to use
the supplied M10-1.5 x 40 hex bolts.
Router Table Main Table
Mounting
Holes
Figure 12. Mounting holes in router table
extension wing and saw table.