-26-
Model G0936 (Mfd. Since 06/21)
Since all the bearings on the Model G0936 are
sealed and permanently lubricated, simply leave
them until they need to be replaced. DO NOT
lubricate them.
Below describes how to lubricate the components
that require periodic lubrication. Do not over-
lubricate these components. Large amounts of
lubricant will attract sawdust, causing the metal
components to gum up and bind.
See
Figure 26 for our recommended NGLI#2
grease for lubricating the leadscrew and trun-
nions.
Lubrication
Leadscrew & Trunnions
To lubricate leadscrew and trunnions:
1. DISCONNECT MACHINE FROM POWER!
2. Remove (4) Phillips head screws and flat
washers shown in
Figure 27 to remove pul-
ley cover.
3. Remove (3) Phillips head screws and flat
washers shown in
Figure 27 to remove left
side cover.
Lubrication Type ...........T26419 or NLGI#2 Equiv
Amount .................................................Thin Coat
Frequency .......................................... As Needed
Items Needed
Qty
Phillips Head Screwdriver #2 ............................ 1
Mineral Spirits .................................... As Needed
Shop Rags ......................................... As Needed
Wire Brushes ..................................................... 2
NLGI#2 Grease ................................. As Needed
4. Remove (4) Phillips head screws and flat
washers shown in
Figure 28 to remove back
cover.
Figure 28. Location of back cover and fasteners.
x 4
Back Cover
Figure 27. Location of pulley cover, left side
cover, and fasteners.
x 3
x 4
Pulley
Cover
Left Side
Cover
T26419—Syn-O-Gen Synthetic NLGI#2 Grease
Formulated with 100% pure synthesized hydrocar-
bon basestocks that are compounded with special
thickeners and additives to make Syn-O-Gen
non-melt, tacky, and water resistant. Extremely
low pour point, extremely high temperature oxida-
tion, and thermal stability produce a grease that is
unmatched in performance.
Figure 26. T26419 Syn-O-Gen Synthetic
Grease.
Summary of Contents for G0936
Page 52: ......
