Grizzly G0936, Owner'S Manual

Page: 11 / 52

Model G0936 (Mfd. Since 06/21)
-9-
Additional Safety for Belt Sanders
Serious injury or death can occur from fingers, clothing, jewelry, or hair getting pinched/
entangled in belt or other moving components. Abrasion injuries can occur from touching
moving sandpaper with bare skin. Workpieces thrown by sanding surface can strike operator
or bystanders with moderate force, causing impact injuries. Long-term respiratory damage can
occur from using sander without proper use of a respirator. To reduce the risk of these hazards,
operator or bystanders MUST completely heed the hazards and warnings below.
WORKPIECE SUPPORT. Workpiece kickback
can occur with violent force if workpiece is not
properly supported during operation. Always sand
with workpiece firmly against table or another sup-
port device.
SANDING DUST. Sanding creates large amounts
of dust that can lead to eye injury or respira-
tory illness. Reduce your risk by always wearing
approved eye and respiratory protection when
using sander. Never
operate without adequate
dust collection system in place and running.
However, dust collection is not a substitute for
using a respirator.
WORKPIECE INSPECTION. Nails, staples, knots,
or other imperfections in workpiece can be dis-
lodged and thrown from sander at a high rate of
speed at people, or cause damage to sandpaper
or sander. Never sand stock that has embedded
foreign objects or questionable imperfections.
SANDPAPER CONDITION. Worn or damaged
sandpaper can fly apart and throw debris at opera-
tor, or aggressively grab workpiece, resulting in
subsequent injuries from operator loss of work-
piece control. Always inspect sandpaper before
operation and replace if worn or damaged.
WORKPIECE INTEGRITY. Sanding fragile work-
pieces can result in loss of control, resulting in
abrasion injuries, impact injuries, or damage to
sandpaper. Only sand solid workpieces that can
withstand power sanding forces. Make sure work-
piece shape is properly supported; avoid sanding
workpieces without flat bottom surfaces unless
some type of jig is used to maintain support and
control when sanding force is applied.
SANDPAPER DIRECTION. Feeding workpiece
incorrectly can cause it to be thrown from machine,
striking operator or bystanders, or causing your
hands to slip into the moving sandpaper. To reduce
these risks, only sand against direction of sandpa-
per travel, ensure workpiece is properly supported,
and avoid introducing sharp edges into moving
sandpaper on the leading side of the workpiece.
IN-RUNNING NIP POINTS. The gap between
moving sandpaper and fixed table/support creates
a pinch point for fingers or workpieces; the larger
this gap is, the greater the risk of fingers or work-
pieces getting caught in it. Minimize this risk by
adjusting table/support to no more than
1
⁄
16
" away
from sandpaper.
HAND PLACEMENT. Rotating sandpaper can
remove skin quickly. Always keep hands away
from moving sandpaper during operation. Stop
machine to clean table of sawdust and chips.
MINIMUM STOCK DIMENSION. Small workpiec-
es can be aggressively pulled from your hands,
causing contact with sanding surface. Always use
a jig or other holding device when sanding small
workpieces, and keep hands and fingers at least
2" away from sanding surface.
FEEDING WORKPIECE. Forcefully jamming
workpiece into sanding surface could cause it to
be grabbed aggressively, pulling hands into sand-
ing surface. Firmly grasp workpiece in both hands
and ease it into sandpaper using light pressure.
AVOIDING ENTANGLEMENT. Becoming entan-
gled in moving parts can cause pinching and
crushing injuries. To avoid these hazards, keep all
guards in place and closed. DO NOT wear loose
clothing, gloves, or jewelry, and tie back long hair.