Grizzly G0850, Owner'S Manual

Page: 27 / 56

Model G0850 (Mfd. Since 01/19)
-25-
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine and
connect to power source.
2. Lock casters so machine will not move.
3. To prevent tripping circuit breaker or sup-
ply fuse, connect machine to dust-collection
system and restrict airflow by partially closing
blast gates to limit motor amperage draw dur-
ing test run.
Note: If a dust-collection system is not avail-
able, you may also restrict airflow by install-
ing 8" blast gates or reduction pipes on each
dust port, or by partially blocking each dust
port with a wooden board.
4. Stand away from intake ports, then press ON
button on control panel (see
Figure 49) to
turn dust-collection motor ON.
5. Dust Collection Indicator and Power Indicator
should illuminate, and motor should run
smoothly with little or no vibration or rubbing
noises. Press OFF button to turn dust-collec-
tion motor
OFF (see Figure 49).
— If you suspect any problems, immedi-
ately turn machine
OFF and disconnect it
from power. Refer to Troubleshooting on
Page 42. If you cannot resolve the prob-
lem, contact our Tech Support at (570)
546-9663 for assistance.
The Test Run consists of verifying the following:
1) The main motor powers up and runs correctly,
2) the main motor shuts down correctly, 3) the
filter cleaning brush motors operate correctly, and
4) the remote control functions properly.
Figure 49. Dust-collection motor OFF and ON
buttons and indicator lights.
ON
Button
Power
Indicator
During operation, DO NOT start machine,
stop it, then attempt to quickly restart it. If
the magnetic switch does not have enough
time to cool down between startup cycles, it
may overheat and malfunction.
OFF
Button
Dust Collection
Indicator