Grizzly G0850, Owner'S Manual

Page: 24 / 56

-22-
Model G0850 (Mfd. Since 01/19)
38. On each brush assembly, loosen set screw
inside brush spindle connector, attach filter
brush assembly to filter cover plate using (2)
1
⁄
4
"-20 x
1
⁄
2
" flat head screws and (2)
1
⁄
4
"-20
lock nuts (see
Figure 35), then tighten set
screw.
Figure 35. Filter brush assembly attached to
filter cover plate.
x 2
Set Screw
39. For each filter brush assembly, place one fil-
ter cover plate gasket on top of impeller hous-
ing, then install filter brush assembly through
top of impeller housing opening.
40. Secure each filter cover plate using (8)
5
⁄
16
"-18 x
3
⁄
4
" hex bolts and (8)
5
⁄
16
" fender
washers and tighten in a cross pattern.
41. Slide each canister filter around brush assem-
bly and attach to impeller housing using (3)
5
⁄
16
"-18 x 1" knob bolts (see Figure 36).
42. Attach bottom of filter brush assembly to bar
on canister filter using (2)
1
⁄
4
"-20 x 1" hex
bolts, (4)
1
⁄
4
" flat washers, and (2)
1
⁄
4
"-20 lock
nuts (see Figure 37).
Figure 37. Bottom of filter brush assembly
attached to canister filter.
x 2
Filter Brush Assembly
43. Attach left filter brush motor to left filter cover
plate with (4)
1
⁄
4
"-20 x
3
⁄
4
" hex bolts and (4)
1
⁄
4
"
flat washers, as shown in
Figure 38.
Note: Left filter brush motor has one strain
relief; right filter brush motor has two. When
installing motors, you may need to have an
assistant rotate filter brush assembly from
below to help align brush shaft with motor
spindle. Turn motor bracket until mounting
holes align with filter cover plate.
44. Tighten (2) set screws on motor spindle (see
Figure 38).
Figure 36. Canister filters installed on impeller
housing.
x 3
Filter Cover Plate
Figure 38. Attaching left filter brush motor to
filter cover plate (viewed from rear of machine).
x 4 Set
Screws
Left Filter
Brush Motor
Filter Brush
Assembly