Model G0834 (Mfd. Since 12/17)
-19-
3. Secure sliding bushing with (1) M12-1.75 lock
nut and (1) 12mm flat washer, as shown in
Figure 17.
2. Lift fence assembly over fence carriage, slip
sliding bushing into the fence carriage slot,
ensuring key fits snugly into key slot, as
shown in
Figure 16.
Figure 16. Aligning fence assembly and fence
carriage.
4. Position and tighten fence tilt handle, as
shown in
Figure 18.
Figure 18. Positioning and tightening fence tilt
handle.
Figure 17. Securing sliding bushing.
Sliding
Bushing
5. Install cutterhead guard shaft into mounting
hole, as shown in
Figure 19, then secure it
using lock knob.
6. Move fence all the way to back of table, then
pull cutterhead guard back and let it go.
It should spring back over cutterhead and
contact fence.
— If cutterhead guard does not spring back
over cutterhead and contact fence, then
cutterhead guard tension must be adjust-
ed (refer to
Adjusting Cutterhead Guard
Tension on Page 44 for instructions).
7. Perform Setting Outfeed Table Height on
Page 37.
Cutterhead guard is a critical safety feature
of this jointer. You MUST install and verify
its operation before using the jointer! Failure
to properly install this guard will greatly
increase risk of serious personal injury.
Figure 19. Installing cutterhead guard.
Lock Knob
Cutterhead
Guard Shaft
Cutterhead Guard
Fence Tilt
Handle
Carriage
Fence
Key
Sliding
Bushing
Keyway
Slot
Carriage Slot
Summary of Contents for G0834
Page 60: ......