Grizzly G0834, Owner'S Manual

Page: 20 / 60

-18-
Model G0834 (Mfd. Since 12/17)
Figure 15. Securing control panel pedestal.
7. Lower jointer into position.
IMPORTANT: Before jointer was shipped
from factory, infeed table was fully raised and
stop bolt was threaded up against bottom of
it to safely secure it during transit. You MUST
adjust position of infeed stop bolt before
attempting to lower infeed table.
8. Loosen jam nut (see Figure 14) on infeed
stop bolt, then unthread stop bolt until table
can be lowered to
1
⁄
8
" on depth-of-cut scale,
then adjust infeed stop bolt back against
infeed table casting and tighten jam nut.
NOTICE
NEVER force table handwheels if you feel
resistance. Check positions of stop bolts or
for obstructions.
Figure 14. Infeed table stop bolt set to stop
infeed table at
1
⁄
8
" maximum depth of cut.
Stop Bolt
Jam Nut
To assemble jointer:
1. Secure control panel pedestal to jointer with
(4) M10-1.5 x 30 cap screws, (4) 10mm lock
washers, and (4) 10mm flat washers, as
shown in
Figure 15.
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Lifting heavy machinery
or parts without proper
assistance or equipment
may result in strains, back
injuries, crushing injuries,
or property damage.
x 4