Grizzly G0791, Owner'S Manual

Page: 71 / 132

Model G0791 (Mfd. Since 9/15)
-69-
Installing/Removing
Tooling
This machine features a spindle that accepts R-8
collets and arbors. It can also use MT#3 or MT#2
tooling with the included adapter sleeves.
The Model G0791 includes the following spindle
tools (see
Figure 106):
A. B16 Drill Chuck w/R-8 Arbor. Refer to
Joining Drill Chuck & Arbor on Page 45.
B. R-8–MT#3 Spindle Sleeve. Used for MT#3
tools and will accommodate tools with a tang.
It also has a drift key slot for tool removal.
C. MT#3–MT#2 Spindle Sleeve. Used with the
R-8–MT#3 spindle sleeve for MT#2 tools.
Cutting tools are sharp and
can easily cause cutting
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
Figure 106. Drill chuck, arbor, and spindle
sleeves included with Model G0791.
A
B
C
Alignment Slot
Installing Tooling
Tools Needed Qty
Wrench 10mm ................................................... 1
Spindle Locking Pin (Not Included) ................... 1
To install tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Verify drawbar is installed correctly (refer to
Page 24).
3. Align tool alignment slot (see Figure 106)
with pin inside spindle, then insert tooling into
spindle until it contacts drawbar.
4. Thread drawbar into tooling by hand until
snug (see
Figure 107).
Figure 107. Threading drawbar into tooling.