Grizzly G0791, Owner'S Manual

Page: 28 / 132

-26-
Model G0791 (Mfd. Since 9/15)
Lubricating Lathe
The headstock, quick-change gearbox, and apron
oil reservoirs must have the proper amount of oil
in them before the lathe can be operated.
Damage caused to the bearings and gears from
running the lathe without oil in the reservoirs
will not be covered under warranty. Refer to the
Lubrication section, beginning on Page 77, for
checking and adding oil.
In addition to the reservoirs, we also recommend
that you lubricate all other points on the machine
at this time.
Note: If this lathe was shipped with oil in the
reservoirs, do not change that oil until after the
test run and spindle break-in procedures.
Power Connection
Before the machine can be connected to the
power supply, there must be an electrical circuit
that meets the
Circuit Requirements for 220V
on
Page 16.
To minimize the risk of electrocution, fire, or equip-
ment damage, installation work and electrical wir-
ing MUST be done by an electrician or qualified
service personnel.
Note About Extension Cords: Using an incor-
rectly sized extension cord may decrease the life
of electrical components on your machine. Refer
to
Extension Cords on Page 17 for more infor-
mation.
Electrocution or fire
may occur if machine is
ungrounded, incorrectly
connected to power, or
connected to an undersized
circuit. Use an electrician
or a qualified service
personnel to ensure a safe
power connection.