Grizzly G0791, Owner'S Manual

Page: 29 / 132

Model G0791 (Mfd. Since 9/15)
-27-
To connect power cord to machine:
1. Press Emergency Stop/RESET button on
front of headstock, then remove electrical box
cover from back.
2. Thread power cord through strain relief shown
in Figure 22.
Figure 22. Location of incoming power strain
relief.
Incoming Power
Strain Relief
3. Identify L and N terminals and grounding
terminal ( PE), illustrated in Figure 23, then
connect incoming hot wires and ground wire
to those terminals
.
Ground
To
Power Source
PE
L N
Figure 23. Incoming power wires connected
inside electrical cabinet.
4. Make sure wires have enough slack between
strain relief and terminal connections so they
are not pulled tight or stretched, then tighten
strain relief to secure cord.
Note: The strain relief must be tightened
against the outer jacket of the cord. Avoid
over-tightening the strain relief or it may
crush the cord and cause a short.
5. Test strain relief to ensure it is properly tight-
ened by pulling cord from outside box with
light-to-moderate force. When strain relief is
properly tightened, cord will not move inside
cabinet.
6. Install NEMA 6-15 plug on other end of power
cord per plug manufacturer's instructions.
7. Re-install main electrical box cover.
8. Plug cord into matching power supply recep-
tacle and power source as specified in
Circuit
Requirements for 220V on Page 16.
To avoid unexpected start-up, keep
Emergency Stop/RESET button pressed in
until instructed otherwise in Test Run.