-28-
Model G0736/G0737 (Mfd. Since 3/14)
Adjusting Table Tilt
To perform beveled cuts, the bandsaw table tilts
15° side to side, and 10° front to back.
Tools Needed
Qty
Hex Wrench 10mm ............................................. 1
Wrench or Socket 17mm .................................... 1
Adjusting Side-to-Side Table Tilt
1. DISCONNECT BANDSAW FROM POWER!
2. Loosen the two cap screws underneath the
rear of the table (see
Figure 33).
3. Using the scale shown in Figure 33 as a
guide, adjust the table tilt and re-tighten the
cap screws to secure the setting.
ALWAYS make sure the
table tilt cap screws and
hex bolts are fully tight-
ened before operation. If
the table shifts while cut-
ting, your hands could
accidentally move into the
blade.
Figure 33. Side-to-side table tilt controls.
Scale
Cap Screws
Adjusting Front-to-Back Table Tilt
1. DISCONNECT BANDSAW FROM POWER!
2. Loosen the four hex bolts underneath the
table—two on each side (see
Figure 34).
3. Using the scale shown in Figure 34 as a
guide, adjust the table tilt and re-tighten the
four hex bolts to secure the setting.
Figure 34. Front-to-back table tilt controls.
Hex Bolts
Scale
Summary of Contents for G0736
Page 72: ......
