Grizzly G0736, Owner'S Manual

Page: 15 / 72

Model G0736/G0737 (Mfd. Since 3/14)
-13-
Power Cord Installation
The power cord used on this bandsaw must meet
the circuit requirements provided on
Page 11,
unless otherwise deemed acceptable by appli-
cable electrical codes.
To minimize the risk of electrocution, fire, or
equipment damage, installation work and elec-
trical wiring must be done by an electrician or
qualified service personnel in accordance with all
applicable codes and standards.
Figure 6. Power connection junction box
opened.
Strain
Relief
Ground
Incoming
Power Cord
Connect
Here
Connect
Here
Strain Relief
Figure 7. Power cord connection in junction box.
6. Remove the hex nuts on the bottom left and
right terminal posts.
7. Secure the power cord hot wires to the bot-
tom left and right terminal posts, as shown in
Figure 7, then secure them with the hex nuts
you previously removed in
Step 6.
8. Make sure the incoming wires have enough
slack between the strain relief and connec-
tions so that they are not pulled tight, then
tighten the strain relief to secure the power
cord.
Note:
The strain relief must be tightened
against the outer jacket of the power cord.
Avoid over-tightening the strain relief or it
may crush the cord and cause a short.
9. Test the strain relief to ensure it is properly
tightened by pulling the cord from outside
the junction box with light-to-moderate force.
When the strain relief is properly tightened,
the cord will not slide through the strain
relief.
10. Re-install the plastic terminal cover, then re-
attach the junction box cover.
Items Needed Qty
Power Cord “S”-Type, 3-Wire, 14 AWG, 300V,
6'–10' Long (see Page 11) ........................... 1
Ring-Type, Clamp-On Wire Connectors,
16–14 AWG, #10 .......................................... 3
Wrench or Socket 8mm ...................................... 1
Phillips Screwdriver #2 ....................................... 1
To connect the power cord to the machine:
1. Open the power connection junction box on
the rear of the machine (see
Figure 6).
DO NOT connect the power
cord to the power source
during this procedure.
Otherwise, electrocution
injuries could occur.
3. Thread the power cord through the strain
relief.
4. Attach the ring terminals on the ends of the
power cord wires.
5. Secure the incoming ground wire to the
ground terminal inside the junction box (see
the illustration in
Figure 7).
2. Remove the plastic terminal cover.