-8-
Model G0727 (Mfg. Since 7/11)
Additional Safety for Mills
Like all machinery there is potential danger
when operating this machine. Accidents
are frequently caused by lack of familiarity
or failure to pay attention. Use this machine
with respect and caution to decrease the
risk of operator injury. If normal safety pre-
cautions are overlooked or ignored, seri-
ous personal injury may occur.
No list of safety guidelines can be com-
plete. Every shop environment is different.
Always consider safety first, as it applies
to your individual working conditions. Use
this and other machinery with caution and
respect. Failure to do so could result in
serious personal injury, damage to equip-
ment, or poor work results.
UNDERSTANDING CONTROLS. The mill is a
complex machine. To reduce the risk of injury,
make sure you understand the use and operation
of all controls before you begin milling.
SPINDLE SPEED. To avoid tool or workpiece
breakage that could send flying debris at the
operator and bystanders, use the correct spindle
speed and feed rate for the operation. Allow the
mill to gain full speed before beginning the cut.
STOPPING SPINDLE. Always allow the spindle
to stop on its own. To reduce the risk of lacera-
tions, entanglement, or breakage debris, DO NOT
attempt to stop the spindle with your hand or a
tool.
SAFETY ACCESSORIES. Flying chips or debris
from the cutting operation can cause eye injury or
blindness. To reduce this risk, always use a face
shield in addition to your safety glasses when
milling.
WORK HOLDING. Attempting to mill a workpiece
that is not properly secured could cause break-
age debris to fly at the operator. Before starting
the machine, be certain the workpiece has been
properly clamped to the table or secured in a vise.
NEVER hold the workpiece by hand during opera-
tion.
CHIP CLEANUP. Waste chips created by the mill-
ing operation are sharp and hot and can cause
cuts or burns. Using compressed air to clear chips
could blow them into your eyes or drive them deep
into the working parts of the machine. Use a brush
or vacuum to clear away chips and debris from the
machine or workpiece. NEVER clear chips while
the spindle is turning.
MACHINE CARE & MAINTENANCE. Operating
the mill with excessively worn or damaged parts
increases the risk of accidents that could cause
serious injuries. A mill that is maintained poorly
will produce poor results. To reduce this risk,
maintain the mill in proper working condition by
ALWAYS promptly performing routine inspections
and maintenance.
CUTTING TOOL USAGE. Cutting tools have very
sharp leading edges—handle them with care!
Using cutting tools that are in good condition helps
to ensure quality results and reduces the risk of
personal injury from broken tool debris. Inspect
cutting tools for sharpness, chips, or cracks before
each use. ALWAYS make sure cutting tools are
firmly held in place before starting machine.
Summary of Contents for G0727
Page 48: ......