Model g0661/g0713 (Mfg. since 1/10)
-41-
5. Center a board at least 2" thick and equal to
the length of the table over the rear open-
ing of the insert, then secure it with clamps
at both ends, as shown in
Figure 56. this
will provide extra support for the insert and
reduce tear out when cutting.
6. set the blade angle at 0°.
Suggestion:
To retain the zero clearance
ability of the insert included with this saw, we
recommend only raising the blade into the
insert at 90° during the following step.
— if you need a zero clearance insert for
compound cuts, install an optional phenolic
zero clearance table insert, Model t21876
(refer to
page 61 for each angled cut, then
follow
Step 7.
— if you plan to use a dado blade to cut rab-
bets or dados, install the included dado
blade insert.
— if you do not require your insert to have a
zero clearance fit, especially if you need to
make a range of compound cuts, you can
modify the insert included with this saw.
Follow
Step 7, then route the underside of
the blade-cut slot to the same width as the
rear opening (see
Figure 55).
7. Connect the saw to power. Keep hands off
of table top, do not stand directly behind the
blade path, and wear eye protection.
8. turn the saw
ON
, then slowly raise the blade
to the maximum height that will be used dur-
ing normal operations.
9. turn the saw
OFF
, lower the blade complete-
ly, then remove the board and clamps.
10. install the blade guard (refer to "installing
Blade guard & spreader" on
page 37).
Figure 56. securing insert with board and
clamps.
Clamps
2" thick Board
insert
1. disConnECt saW FroM poWEr!
2. Check to make sure the blade is properly
installed (refer to the instructions in
Blade
Installation on page 36).
3. install the table insert, as shown in Figure
55.
Cutting a zero
Clearance Insert
a zero clearance insert is provided with the table
saw to reduce workpiece tear out and increase
user safety. the insert can be customized to fit a
specific blade height or blade angle for the appli-
cable cutting operation.
To install the zero clearance insert:
4. adjust the table insert set screws with a
2.5mm hex wrench to make sure the insert is
flush with the table (use a straightedge as a
guide), then turn the lock knob to secure the
insert.
Figure 55. insert knob in lock position.
lock Knob
rear
opening
set screws
Front
of saw
