Grizzly G0623X, Owner'S Manual

Page: 34 / 80

-32-
G0623X/G0623X3 10" Sliding Table Saw
Test Run
After the machine has been connected to the
power source, the machine MUST be test run to
make sure all the controls and safety components
function properly before the machine is placed
into regular operation.
It is extremely important that all steps in this sec-
tion be followed very closely, in the order given,
to ensure that the safety features are tested cor-
rectly.
Before beginning the test run, review the power
controls shown in
Figure 50 and Controls &
Features
on
Page 9
.
Power Connection
Before connecting the saw to power, read through
SECTION 2: CIRCUIT REQUIREMENTS
to
check that your setup follows the safety and circuit
requirements for your model.
Open the power connection box shown in
Figure
48 .
Figure 48. Power connection box.
Power
Connection Box
Connect the power wires to the terminals shown
in
Figure 49
, tighten the strain relief so the wires
can't be pulled from the terminals, then close the
power connection box.
Note for G0623X3:
If using a phase converter,
connect the manufactured power leg to the S ter-
minal to prevent damage (see
Page 15
).
Figure 50.
Main power controls.
ON Button
STOP Button
If the machine does not operate as stated
in this section, review the troubleshooting
section on Page 49. If you need additional
help, call Tech Support at (570) 546-9663.
DO NOT place a machine into regular opera-
tion if you suspect that it is malfunctioning,
or serious injury could occur.
Figure 49.
Main terminal boxes.
G0623X
G0623X3
R
Ground
S
Ground
S
T
R