Grizzly G0623X, Owner'S Manual

Page: 25 / 80

G0623X/G0623X3 10" Sliding Table Saw
-23-
Moving & Placing
Table saw cabinet
To remove the saw base unit from the crate
pallet:
1.
Feed the lifting straps around the lifting bolts
on the back of the table and the sliding table
saw mounts on the front of the cabinet (see
Figure 14 ). Attach the ends of the lifting
straps to the forklift forks.
Figure 14.
Lifting the table saw cabinet.
2.
Lift the table saw cabinet and move it to your
predetermined location.
3. Remove the red lifting bolts from the back of
the table.
4.
Place a level on the cast iron table to level
the table saw cabinet side-to-side and front-
to-back. This will allow the table to slide
smoothly.
Note: There are three options for leveling the
saw: 1) Place it on a mobile base (Grizzly
Model G7315) and use the mobile base con-
trols to level it, 2) shim under the cabinet, and
3) thread bolts down into the nuts welded on
the stand corners (
Figure 15
).
Figure 15.
Hex bolt in stand corners for leveling;
the hex nut is used to secure bolt position.
DO NOT lift the table saw any higher than
necessary to clear the floor. Serious per-
sonal injury and damage to the machine
may occur if safe moving methods are not
followed.
Make sure your lifting straps will hold the
weight of the machine. If a lifting strap
breaks, serious personal injury may occur.
This machine weighs
over 500 lbs. Serious per-
sonal injury may occur
if safe moving methods
are not followed.
To be safe, you will need
another person for assis-
tance and a forklift when
moving the shipping
crate and removing the
machine from the crate.