Grizzly G0623X, Owner'S Manual

Page: 17 / 80

G0623X/G0623X3 10" Sliding Table Saw
-15-
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the setup pro-
cess. DO NOT connect the machine to the
power source until instructed to do so.
G0623X 220V
Single-Phase
Grounding
In the event of an electrical short, grounding
reduces the risk of electric shock. The grounding
wire in the power cord must be properly connected
to the grounding prong on the plug; likewise, the
outlet must be properly installed and grounded.
All electrical connections must be made in accor-
dance with local codes and ordinances.
Amperage Draw
The Model G0623X motor draws the following
amps under maximum load:
Motor Draw at 220V ..............................22 Amps
Circuit Requirements
We recommend connecting your machine to a
dedicated and grounded circuit that is rated for
the amperage given below. Never replace a circuit
breaker on an existing circuit with one of higher
amperage without consulting a qualified electri-
cian to ensure compliance with wiring codes.
If
you are unsure about the wiring codes in your
area or you plan to connect your machine to a
shared circuit, consult a qualified electrician.
Minimum Circuit Size .............................30 Amps
Plug/Receptacle Type
Recommended Plug/Receptacle ....NEMA L6-30
Electrocution or fire could
result if this machine is
not grounded correctly
or if your electrical con-
figuration does not com-
ply with local and state
codes. Ensure compliance
by checking with a quali-
fied electrician!
Figure 2. NEMA L6-30 plug and receptacle.
SECTION 2: CIRCUIT REQUIREMENTS
Extension Cords
Using extension cords may reduce the life of the
motor. Instead, place the machine near a power
source. If you must use an extension cord:
• Use at least a 10 gauge cord that does not
exceed 50 feet in length.
• Ensure that the extension cord contains a
ground wire and plug prong.
Power Cord Requirements
Use a stranded-copper flexible cord that meets
the minimum requirements listed below, does
not exceed 50 ft., and has an insulation type
that starts with "S." A qualified electrician MUST
determine the best cord to use in your environ-
ment depending on exposure to moisture, heat,
and oils.
G0623X 220V 1-Phase .........10/3 AWG, 300VAC