Grizzly G0623X, Owner'S Manual

Page: 31 / 80

G0623X/G0623X3 10" Sliding Table Saw
-29-
29.
Adjust the feet downward so they press
against the floor, then tighten the hex nuts up
against the support leg so the feet are locked
in place.
30.
Open the cabinet door and remove the motor
shipping brace shown in
Figure 36 .
31.
Tilt the blade assembly to 0˚, then slide the
sliding table forward all the way until you can
open the lower blade guard cover and access
the blade arbors.
Figure 36.
Motor shipping brace.
34.
Install the riving knife as shown in
Figure 39
,
but do not tighten the mounting bolt yet.
Figure 39.
Installing riving knife.
Figure 40.
Adjusting the riving knife spacing.
35.
Adjust the riving knife approximately
1
⁄
8
" away
from the main blade, using a
1
⁄
8
" or 3mm hex
wrench as a guide (
Figure 40
).
32.
Insert the arbor lock tool into the hole shown in
Figure 37 , rotate the arbor until the arbor lock
tool seats, then install the main blade, using
the included arbor wrench. There MUST be
an arbor flange on both sides of the blade.
Figure 37. Installing main blade.
Arbor
Lock
Tool
33.
Insert the arbor lock tool into the hole shown
in
Figure 38 , rotate the arbor until the arbor
lock tool seats, then install the scoring blade,
using the arbor wrench. There MUST be an
arbor flange on both sides of the blade.
Figure 38. Installing scoring blade.
Arbor
Lock
Tool