Model G0510ZW (Mfd. Since 9/16)
-43-
6. Remove drawbar taper nut from bottom of
spindle, as shown in
Figure 65, and slide
pulley off.
4. Loosen both motor mount bolts, slide motor
forward, and remove V-belt.
5. Loosen spindle lock knob (see Figure 64).
Figure 64. Spindle lock knob.
Spindle
Lock
Knob
7. Hold your hand under the spindle cartridge
and remove the elevation handle by unthread-
ing it counterclockwise. Spindle cartridge
should drop into your hand.
8. Install new cartridge assembly in reverse
order of disassembly.
Figure 65. Loosening drawbar taper nut.
Spindle
Elevation
Handle
Taper
Nut
Figure 63. Spindle drawbar cover bolts.
Replacing Spindle
Cartridge Assembly
The spindle cartridge assembly features factory-
sealed bearings. A sealed bearing requires no
lubrication during its lifetime.
If a bearing fails, your shaper will probably devel-
op a noticeable rumble, which increases when the
machine is put under load. If allowed to worsen,
overheating of the housing containing the bad
bearing could occur, which may cause the bearing
to seize and possibly damage other parts of the
machine.
The replacement procedure can be accomplished
in 15-20 minutes.
Tools Needed:
Qty
Spindle Wrench 26mm ...................................... 1
Wrench/Socket 19mm ....................................... 1
Open-End Wrench 13mm .................................. 1
Open-End Wrench 8mm.................................... 1
Replacement Spindle Cartridge Assembly ....... 1
To replace spindle cartridge assembly:
1. DISCONNECT MACHINE FROM POWER!
2. Remove spindle and drawbar from spin-
dle cartridge assembly. (Remove tapered
drawbar nut and tap drawbar up to knock it
loose.)
3. Remove spindle drawbar cover by removing
two mounting bolts shown in
Figure 63.
Summary of Contents for G0510ZW
Page 16: ...5mm Hardware Recognition Chart...
Page 52: ...50 Model G0510ZW Mfd Since 9 16...
Page 56: ......
