Grizzly G0510ZW, Owner'S Manual

Page: 42 / 56

-40-
Model G0510ZW (Mfd. Since 9/16)
4. Loosen and remove taper nut (see Figure
56), while holding spindle top with an 8mm
wrench.
Figure 56. Removing taper nut from drawbar
(located beneath table).
5. Gently tap bottom of drawbar with wrench to
knock spindle loose.
6. Remove spindle/drawbar assembly from
spindle cartridge.
7. Place desired collet into collet nut by pushing
it in until it snaps (see
Figure 57).
Figure 57. Collet snapped into collet nut.
Collet Nut
Taper Nut
Collet
8. Insert collet assembly into spindle cartridge,
and tighten until collet nut and collet are flush
on top, as shown in
Figure 58.
9. Place table spacers over table mounting
holes (see Figure 59).
10. Place table over spacers and secure it to
shaper with hex bolts from router table spacer
kit (see
Figure 59).
11. Keep removed table bolts for when convert-
ing back to use as a shaper.
7 Spacers
5 Long Bolts
2 Short
Bolts
Figure 58. Collet flush with top of collet nut.
Tighten Until
Surfaces Are Flush
Figure 59. Installing table spacers to convert
shaper to router table