Model G0510ZW (Mfd. Since 9/16)
-19-
Preparing Spindle
for Test Run
To ensure your safety during the test run, make
sure the spindle nut and rub collars are tight,
or just completely remove the spindle nut and
rub collars. If these items are loose during the
Test Run, they could fly off and strike operator or
bystanders with great force.
To prepare spindle for test run:
1. Remove (2) hex bolts and pulley guard, as
shown in
Figure 16, to access drawbar nut.
Figure 16. Location of pulley guard.
Pulley
Guard
Hex
Bolt
Hex
Bolt
2. Verify spindle and spindle nut are tight, as
shown in Figure 17.
Note: If removing spindle nut, only hold
spindle at spindle flats to keep spindle from
rotating. Do not hold spindle at drawbar nut
when removing spindle nut, as this could
loosen drawbar nut.
3. Re-install pulley guard.
Figure 17. Ensuring spindle is tight.
Spindle
Nut
Rub
Collars
Drawbar
Nut
Spindle
Flats
Summary of Contents for G0510ZW
Page 16: ...5mm Hardware Recognition Chart...
Page 52: ...50 Model G0510ZW Mfd Since 9 16...
Page 56: ......
