8
16.
Attach the
2.0
label to the wall controller, as shown below.
The limit LED should be ON (i.e. no limits set) before operating with new conversion kit. If limits are set, they must be bombed,
then reset. To bomb limits:
Hold
stop
and press
set
3 times
(limit LED should begin to flash)
Press
set
(limit LED will flicker)
Run door open for less than 2 seconds, then press
set
(limit LED should become solid)
Cycle power and reset limits, refer to 2.0 manual (included) for limit setting procedure
For accessory compatibility and set-up please refer to page 18-20 of the 2.0 manual (included in package)
Before
After
