3
8.
Use the provided M4 hex head taptite to drive in and out of the hole shown below, to form a thread. Use a Phillips head
style screwdriver.
9.
Reinstall the enclosure, observe orientation as before. Insert two of the original screws as shown to assist enclosure
mounting. Install APE cable, (must pass through foam pad into MCB enclosure).
10.
Use the provided M4 hex head taptites to drive in and out of the holes shown below. There should be a clearance of approx
1mm between the base of the enclosure and the hex head to ensure adequate thread depth has been achieved .
APE cable entry
2 x original screw
Standard Opener:
Holes requiring M4 thread
to be formed by screwing
taptite in and out.
Right hand enclosure
Left hand enclosure
Clutch Model:
Holes requiring M4 thread
to be formed by screwing
taptite in and out.
NOTE: Ensure all excess debris is removed from the enclosure after
threading holes.
