11: Monitor Mode
Monitor Mode is a command-line interface used for diagnostic purposes. There are two ways to
enter Monitor Mode: locally using the serial port or remotely using the network.
Entering Monitor Mode Using the Serial Port
To enter Monitor Mode locally:
Follow the same steps used for setting the serial configuration parameters.
Instead of typing three
x
keys, however:
Type
zzz
(or
xx1
) to enter Monitor Mode with network connections.
Type
yyy
(or
yy1
) to enter Monitor Mode without network connections.
A
0>
prompt indicates that you have successfully entered Monitor Mode.
Entering Monitor Mode Using the Network Port
To enter Monitor Mode using a Telnet connection:
From the Windows
Start
menu, click
Run
and type the following command, where x.x.x.x is the
IP address, and 9999 is the unit’s fixed network configuration port number:
Windows:
telnet x.x.x.x 9999
UNIX:
telnet x.x.x.x:9999
Click
OK
. The following information and login prompts display (see
MAC Address and Login Prompt
MAC address 00204A9D028B
Software version V6.9.0.0RC3 (120828) NETDIRECT
AES library version 1.8.2.1
User Name :admin
Password :----
Press Enter for Setup Mode
Enter
User Name
(user name is admin and cannot be changed). Pressing the
Enter
key after
entry is not necessary. The
Password
field will appear.
Enter
Password
(default password is PASS). Pressing the
Enter
key after entry is not
necessary. You will be prompted to enter Setup Mode.
Password can be modified or disabled. See
Server Configuration (on page 26)
.
Type
M
(upper case) immediately.
A
0>
prompt indicates that you have successfully entered Monitor Mode.
Summary of Contents for NetDirect
Page 1: ...NetDirect User Guide ...