begins and the red Diagnostic LED starts blinking.
You have
one second
to enter three
lowercase
x
characters.
The easiest way to enter Setup Mode is to hold down the
x
key at the terminal (or
emulation) while powering up the unit.
Select
0
(Server Configuration) and follow the prompts until you get to
IP address
.
Enter the new IP address, subnet mask, and gateway (if applicable).
Do one of the following:
Continue with
Chapter 6: Configuration Via Telnet or Serial Port (Setup Mode)
.
Select
9
to save and exit Setup Mode. The unit performs a power reset.
Summary of Contents for NetDirect
Page 1: ...NetDirect User Guide ...
