38
Hedge Cutter RC 162
Torque settings for hose connector
Torque settings for fittings
BSP size
Torque setting
BSP size
Torque setting
1/4 “
24 Nm
18 ibs/ft
1/4 “
34 Nm
25 ibs/ft
3/8”
33 Nm
24 ibs/ft
3/8”
75 Nm
55 ibs/ft
1/2”
44 Nm
35 ibs/ft
1/2”
102 Nm
75 ibs/ft
3/4”
84 Nm
62 ibs/ft
3/4”
183 Nm
135 ibs/ft
1”
115 Nm
85 ibs/ft
1”
203 Nm
150 ibs/ft
Oil Supply:
•
Daily before starting up check oil level in tank reservoir.
•
It is a good practice to constantly keep an eye on the tank level gauge, (this can be seen
from the tractor seat) as a pipe burst could empty the tank within minutes.
•
A pump or motor starved of oil will be damaged beyond repair.
•
Replace oil if signs of contamination occur (discolouration)
•
Use correct and suitable hydraulic oil
•
Contamination can be reduced by
:
•
Thoroughly cleaning around reservoir cap before removing
•
Using a clean container when replenishing the system
•
Regularly servicing the filtration system
.
•
Never allowing oil level to fall below the sight gauge
.
•
Daily inspect all hydraulic connections and fittings to be in good order. Any damage or
leaks must be rectified immediately; this is part of the daily maintenance and is your
responsibility, to maintain a long reliable working life.
•
When tightening fittings always use two spanners when necessary and do not over
tighten. If a fitting leaks it will need to be replaced
Summary of Contents for RC 162
