GreenTec RC 162, Handbook

Page: 37 / 52

Hedge Cutter RC 162 37
Carefully check condition of all hoses during routine service
paying particular attention to chafed
Fejl! Bogmærke er ikke
defineret. outer casing.
Daily inspect all hydraulic hoses and fittings to be in good
order. Any damages or leaks must be rectified immediately;
this is part of the daily maintenance and is your responsibility,
to unsure a long reliable working life.
Hoses with damaged metal braid should be replaced.
When replacing hoses avoid twisting fitting, use two spanners
to slacken and tighten
The GreenTecs hydraulic system works at very high
pressure, when replacing hoses use only genuine hoses, a
burst hose could be very dangerous.
Always check the black protective sleeve is in good order, to
replace sleeve is far cheaper than replacing expensive hoses.
Lubrication:
After machine wash:
Lubricate all machine parts and extra equipment after each wash (if lubrications points
are present) Wash never directly on bearings.
Hydraulic hoses:
Warning!
Hose is weakened when
installed
in twisted
position. Also, pressure
pulses in a twisted hose
tend to fatigue wire and
loosen
fitting
connections. Design so
that
the machine
produces bending rather
than torsion
Please read the following advice carefully!
Hose warranty is limited to replacement of hoses due to faulty materials or
manufacture. Warranty will not be considered on: hoses damaged by chafing,
abrasion, cuts or pinching while in work, or to damaged threads due to over tightening.