Greentec HL152- 242 Cutterbar
34
►
Tighten the bolts on the
head bearing to the specified
tightening torque.
►
Check the cutting gap for
parallelism.
►
Observe the section while it
runs very slowly.
If the knife scrapes or does not
run straight in the cutting gap,
the cause must be determined
and eliminated.
Replace the guard
A guard must be replaced if it is bent or damaged, or if the cutting gap has reached
the wear mark of 5.4 mm.
Remove the double guard
►
Unscrew the nuts on the
damaged double guard and
remove the bolts.
►
Push the double guard to the
side in order to access the knife
bolts.