Greentec HL152- 242 Cutterbar
21
Start-up
►
Check that the hedge trimmer, the tool frame and the vehicle are free
from defects. If a part is missing or loose or damaged, the tool must not be
used.
►
Check that the mechanical and hydraulic connections, the hydraulic
hoses and transport fittings (e.g. lights and warning and protective devices)
are fixed properly and fully functional.
►
Remove any supports.
►
Drive out where there is a space of 5 m all the way
around the vehicle.
►
Unfold the tool frame.
►
Demount the protective guard by pulling the hook on
the rear edge of the cutterbar.
WARNING!
Running machine
There is a risk of personal injury from machine parts that
are running or moving.
►
Check that there are no people within the danger
zone, where they can be hit by the machine.
►
Let the vehicle idle and carefully open the hydraulic oil
►
The trimmer now starts to work.
►
Let the machine idle until the oil is at operating temperature. If the temp.
is below -10
o
C, this could take up to 15 minutes.
►
Now increase the vehicle’s speed until the trimmer is supplied with the
correct quantity of oil. From 15 to 40 l/min, depending on engine type.
•
OMR 80 requires 15-30 l/min
•
OMR 100 requires 20-40 l/min
Figur 4
– Protection guard
- 2 stk. kroge holder
afskærmningen.