Ultra Tugger
®
Cable Puller and Pulling Packages
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
27
Setup—Pipe Adapter
(cont’d)
7. Install two pins from the motor side. Secure the pins
with two hitch pin clips.
Install Hitch Pins
from Motor Side
Install Hitch
Pin Clips on
Capstan Side
Setup—T-Stand
Requires: Adequate clearance. See Typical Setups
Illustrated
1. Set the puller on the floor with the mounting holes
upward.
2. Position the boom mount so that the puller gearbox
will fit into the cradle of the boom mount and the puller
mounting plates straddle the boom mount plates.
Boom Mount
Plates
Boom Mount
Cradle
Gearbox
Puller
Mounting
Plates
3. Mount the boom mount to the puller.
4. Install two pins from the motor side. Secure the pins
with two hitch pin clips.
Install Hitch Pin Clips
on Capstan Side
Install Hitch Pins
from Motor Side
5. Align the two sets of holes in the T-stand with the
two sets of holes in the boom mount.
6. Install two pins. Secure the pins with hitch pin clips.
T-Stand
Insert
Pins Here
7. Continue with Setup: Mounting Components later
in this manual.
