Ultra Tugger
®
Cable Puller and Pulling Packages
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
28
Setup—Wheeled Carriage
Requires: Adequate clearance. See Typical Setups
Illustrated
1. Mount the boom mount to the wheeled carriage.
Align the boom mount holes with the top holes in
the wheeled carriage, as illustrated. Install a pin
through the boom mount and wheeled carriage.
Secure the pin with a hitch pin clip.
2. Position the puller’s gearbox above the boom mount
cradle. Align the puller so that the puller mounting
plates straddle the boom mount plates. Lower the
puller onto the boom mount. Install two pins from
the motor side. Secure the pins with two hitch pin
clips.
3. Check the right angle sheave support tube to be
sure it is fastened with the pin.
Removable Pin
4. Rotate the puller and boom mount as shown. When
the second hole in the boom mount is aligned with
the second hole in the wheeled carriage, install a
pin. Secure the pin with a hitch pin clip.
