Ultra Tugger
®
Cable Puller and Pulling Packages
Greenlee / A Textron Company
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
25
Setup—Pipe Adapter
As of 2006, the pipe adapter has been discontinued and replaced by the 11147 boom adapter.
This information is reference for existing units.
Requires: Exposed metallic pull conduit of least
63.5 mm (2-1/2") diameter
Do not mount the pipe adapter to
the following:
steel conduit less than 65 mm
(2-1/2”) in diameter
PVC conduit of any size
These conduits will not support the
loads imposed by the puller.
Failure to observe this warning could
result in severe injury or death.
•
•
NO
NO
When setting up the pipe adapter,
do not use the vise chains on a
structural support that is less than
51 mm (2") or more than 254 mm
(10") wide. An oversized or under-
sized structural support can allow
the puller to slide or break loose and
strike nearby personnel.
Failure to observe this warning could
result in severe injury or death.
Mount pipe adapter only to conduit
to be pulled from.
Failure to observe this warning could
result in severe injury or death.
1. Remove the sheave from the frame.
Sheave
Sheave Shaft
Hitch Pin Clip
Frame
2. Position the frame against the conduit.
