t
hermoStat
I
nStallatIon
1.
Remove the outer door and the right side cabinet for easy
access to screws securing unit to pallet, there are four T-20
screws at the front and three at the back of each cabinet side.
2.
Loosen four T-20 screws securing Bottom Back Grill, once
loose, slide down and remove.
3.
The harness will need to be unplugged from the board
in order to move cabinet side away from the unit. Once
the harness is unplugged you can easily access the circuit
board and will be able to attach the thermostat wires to the
thermostat connection shown in Figure 26.
4.
Use a small flat head screwdriver to tighten and secure the
wires. The wires should be run through the plastic bushing
located at the back of the stove, opposite side from the
power cord.
5
. Reverse steps 3-1
Figure 26: Thermostat Wire Location
Figure 26a: Circuit Board Location
Connect Thermostat
wires here.
Circuit board
location
Plastic
bushing
22
| GF40 Freestanding Pellet Stove
|
22
installation
Summary of Contents for GF40-2
Page 42: ...42 GF40 Freestanding Pellet Stove 42 warranty ...
Page 43: ......
