__________________________________________________________________________________
Green-GO Quad 4-wire – Quick Start Guide
Configuration cloning
All devices on the local Green-GO network need to have the same configuration to be able to
communicate with each other.
Clone Config
à
Clone a configuration file from the network
Configuration File A
à
Load configuration file A
Configuration File B
à
Load configuration file B
etc.
Factory Default
à
Load the factory default configuration file
Set up Network
In the Network menu you can set up the Network setting of the Internal Green-GO network.
Dynamic
à
Select the connection mode.
ON
à
Use a dynamic IP. If an DHCP server is on the network this will supply an
IP address to the device. If there is no DHCP server the device will self-assign
a Link local IP.
OFF
à
Use a static IP
IP address
à
Set the IP address to be used
Netmask
à
Set the netmask to be used
Gateway
à
Set the gateway to be used
Save
à
Save the current network setup
Cancel
à
Discard current network changes
Device options
Device specific settings can be modified in this menu.
Device Options
Exit
à
leave this menu range is 0.5 – 5.0 seconds.
Backlight
à
Set the time out of the display. Always on, or a range from 10 seconds
through 4 hours.
Display
à
Set the Intensity of the display to dark or bright.
Generic device settings
