__________________________________________________________________________________
Green-GO Quad 4-wire – Quick Start Guide
Set up a 4wire port as General-purpose line In/Out
Set up a 4-wire port as General-purpose Line in/out. This is a simple Line in and out to feed
audio lines into and out of the Green-GO network. for example, Program audio or an
Announcement system.
Mode: Line in/out
In
à
Set up the Input of this 4-wire port.
Group
à
Select a group from your config to which this input will be
assigned.
AutoGain
à
Set the dynamic amplification to avoid distortion. Available
settings are Slow/Med/Fast/Off. If AutoGain is turned off the Max
Gain becomes gain.
MaxGain
à
Set the maximum gain of the input signal - range is from -
12 to 28 dB.
Threshold
à
Set the gate function for this input. The threshold is the level
required for the input signal to be transmitted – editable range is
from -45 to -20dB or turned Off.
Hold
à
Set up the Gate hold time for this input. Options: Fast / Med /
Long / XLong
Bandwidth
à
Set up the used bandwidth for this input
Normal
à
7kHz bandwidth is used for this input
Enhanced
à
14kHz bandwidth is used for this input
In
à
Set up the input source for this input. Line In or a 125 Hz to 4 kHz
test tone
Out
à
Set up the output of this 4-wire port.
Group
à
Select a group from the config to which the output will be assigned.
Output
à
Set the output level of the Line Output. Available range is MUTE,
-42 to 6 dB.
LoopBack
à
Set the level of the LoopBack from 0 to -39 dB or turn it off
