Gree U-Match 5 Series, Manual

Page: 117 / 224

GREE U-Match 5 SERIES UNIT SERVICE MANUAL
114
Removal of condenser
Note: Before removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
5. Take out the condenser.

Loosen the securing screws of
condenser support. Take off
the plate type heat exchanger
and the support as a whole.
6. Install the new condenser.

Secure the screws of
condenser and support. Then
fix them together on the
chassis.

Install the condenser by
referring to the positions of
entering and leaving pipes.
Weld the connection pipes.

Nitrogen welding: the pressure
of nitrogen is 0.5±0.1kgf/ c
㎡
(relative pressure). Note:
When welding the pipes, do
not let the flame burn the other
components.
7. Secure the electric box and
arrange the wires according
to the requirement.

Put the electric box in place
and tighten up the screws of
electric box.

Arrange and secure the wires
as original.
8. Check and open the upper
and side panels.

Check whether each
component and connection
wire is well connected.

If everything is OK, place back
the upper, left and right side
panels.