❏
17. Glue the die-cut 1/8" plywood former F-2B to the back
of former F-2A.
❏
18. Drill 3/16" holes through the punch marks at the
locations shown on the die-cut 1/8" plywood formers F-4 and
F-5. These holes are for mounting the outer pushrod tubes.
❏
1. Install former F-2A on the right fuse side so that the
embossed F-2A faces forward. With F-2A inserted into the
notches, perpendicular to the fuse side, use thin CA to glue
the former in place.
❏
2. Use the die-cut 1/8" plywood former gauge #4 to hold
the die-cut 1/8" plywood former F-4 at the proper angle to
the fuse side while gluing the former in place.
❏
3. Lay the fuse on its left side and insert former F-2A into
the notches on the left side. With F-2A perpendicular to the
to the left fuse side, glue the former to the fuse side.
❏
4. Install the die-cut 1/8" plywood former F-3 into the
notches in the left and right fuse sides. Do not glue the
former to the fuse sides.
❏
5. Lay the fuse on its left side. Use former gauge #4 to
hold F-4 in position while gluing it to the fuse side.
Join the Fuselage Sides
23
