26
❏
7. Lay one of the strips of MonoKote on the bottom
of the wing with the edge extending forward of the hinge
gap by approximately 1/8" [3mm]. Use a regular covering
iron to iron the piece of covering to the wing only.
❏
8. Use a trim iron to seal the covering tightly all the way
down the trailing edge of the wing only.
❏
9. Now seal the strip down the leading edge of the aileron.
❏
10. Trim any excess covering as necessary, or simply
iron it down to the bottom of the aileron.
❏
11. Remove the tape that was holding the aileron
down, then move the aileron up and down a few times
to make sure it moves reasonably smoothly. Make any
adjustments necessary.
❏
12. Seal the top of the aileron and the top and bottom
of the other aileron the same way.
❏
13. Any glue or residual MonoKote adhesive that may
have been deposited on the strips may be cleaned with a
small paper towel square and CA debonder.
❏
14. Use a 3/8" [9.5mm] brass tube sharpened on the
end or a hobby knife to cut a hole in the wing sheeting and
through the foam to pass the aileron servo wire. Install
the aileron servo. Drill 1/16" [1.6mm] holes for the servo
mounting screws and mount the servo with the screws.
Remove the screws, add a few drops of thin CA to the
screw holes and allow the CA to harden.
13/16"
[20mm]
Swivel
