First contact
L-SOLUTION 700 / 800 / 900 machines
. 7
Never operate the LASER system without the machine protective casing.
Never operate the LASER system if the doors are in bad condition or can not be closed
properly.
Never operate the LASER system without constant supervision of the cutting and
engraving process.
Exposure to the LASER beam may cause ignition of combustible materials and start a
fire. A properly maintained fire extinguisher should be kept on hand at all times.
Never operate the LASER machine without a properly configured, installed, maintained,
and operating fume/smoke exhaust system.
Fumes and smoke from the engraving process must be extracted from the LASER
system and exhausted outside.
Never engrave or cut with LASER materials which may produce toxic and corrosive
fumes. DISCONTINUE processing any material that shows signs of chemical
deterioration of the LASER system (Systems damaged from this abuse will NOT be
covered under warranty).
We suggest that you obtain the Material Safety Data Sheet (MSDS) from the materials
manufacturer. The MSDS discloses all of the hazards that may arise from handling or
processing that material. The law requires all manufacturers to provide this informa-
tion to anyone who requests it.
DO NOT ENGRAVE OR CUT PVC (Polyvinylchloride) BASED MATERIALS. The fumes are
extremely toxic if you inhale them. The fumes are so corrosive that they can chemically
destroy the metallic parts of the LASER system. Damage to the LASER system from this
type of abuse WILL NOT be covered under warranty.
Never work on the electronics and LASER parts of the machine without having
unplugged the machine, as hazardous voltages are present.
Although access to these areas is not necessary during normal use, should you need
to open one of these enclosures for service reasons, please remember to unplug the
machine first.
Never move or lift the LASER machine without the assistance of one (or three) person.
(176.4 to 375 lb - 80 to 170 kg). Severe bodily injury may occur if improper lifting
techniques are applied.
Be careful not to drop the LASER system. Not only can it cause bodily harm, but it can
also severely damage the equipment and render it inoperable.
Do not move, push, press on, or shake the LASER machine while the engraving is in
progress. This might shove the engraving part aside and make the engraving
unsuccessful.
Do not connect this equipment to an IT power supply card.
• If the machine is to remain unused for a long period, unplug the power supply and cover the machine (packaging, cover,
lid, etc.)
• Do not move the focus carriage holder manually except in case of a mechanical jamming of the machine, as described
in the paragraph entitled "Mechanical jamming" in this manual's "Installing" chapter.
• Do not spill any liquids onto the machine (drinks, cleaning fluids, etc.) unless recommended by GRAVOGRAPH (e.g. for
lubrication).
• If the engraving process must be stopped, use the function key provided for this purpose on the keyboard of the machine.
Overview
Summary of Contents for L-Solution 700
