GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors 04/2011
8
Mount the swivel pushrod connector in the output arm of the throttle servo using the
screw and nuts, and check that it rotates smoothly, without noticeable slop. Secure
the nuts with a drop of UHU thread-lock fluid to prevent the connector working loose.
Open up the linkage holes in the elevator servo output arm to 1.8 mm Ø.
Connect the clevises to the rudder and elevator horns as shown in the photo.
Set the control surfaces to neutral, centre the servos from the transmitter, and
connect the pushrods to the servo output arms. Repeat the procedure with the
pushrod between the rudder and the tailwheel. When the rudder is at centre, the
tailwheel must be at neutral, otherwise the model will not roll straight on the ground.
